WARRIOR WEP8061HT, Руководство пользователя

Страница: 14 / 39

14
BATTERY CHARGER
SPECIFICATIONS
Charger: C8360/8362
Input: 120-240VAC, 50/60Hz, Max.3A
Output: 63VDC. Max.4.5A
Weight: 2.6 lbs (1.2kg)
CHRGING PROCEDURE (See Figure 5.)
NOTE:
The battery is not shipped fully charged. It is recommended to fully charge before first use
to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a
memory and may be charged at any time.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take more time to fully charge the battery. This will enhance the life of the
battery. Once it is fully ch
a rged, the next charge will return to standard charging.
A fully discharged battery pack will require the allotted time as stated in the battery manual.
Plug the charger into an AC power outlet. Insert the battery pack into the charger.
This is a diagnostic charger. The Charger LED Lights will illuminate in specific order to
communicate the current battery status. They are as follows
· :
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery
from the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is
properly charging. If the status LED is still blinking RED, remove the battery and unplug the charger
for 1 minute. After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks
GREEN, then the battery is properly charging. If the status LED is still blinking RED, the battery is
defective and needs to be replaced
.
Fig. 5
Charging
Fully
Charged
Charging
Fault
Over
Temperature
Stand by