INTIG 250 PULSE DC Pulse Argon Welding Machine
Safety Depends on You
Our arc welding and cutting equipment are designed and built with ample safety consideration. However, proper
installing and operating the machine can increase your safety.
DO NOT INSTALL, OPERATE OR REPAIR THIS EQUIPMENT CASUALLY WITHOUT READING THIS MANUAL
THROUGHOUT.
Special Attention (Very Important):
1. BE SURE TO AVOID THE WELDING MACHINE FALLING DOWN WHEN IT IS PLACED ON
THE GRADIENT GROUND.
2. IT
’S FORBIDDEN UNFREEZING THE PIPELINE BY THE WELDING MACHINE.
3. THE SHIELD RANK OF THIS SERIES OF WELDING MACHINES IS IP23E.
4. The rated duty cycle of this welding machine is 60%, there is protection function when the
machine is overloading used. When
it’s protected and no power output, must wait and after
the temperature back to normal, then use again.
5. When welding current is lower than 200A, the argon gas flow is 4-8L/min, when welding
current is higher than 200A, the argon gas flow is 8-15L/min.
Purchase Date
：
Serial Number
：
Machine Type
：
Purchase Place
：
