WARPP INARC IH SERIES, Руководство по эксплуатации

Страница: 6 / 24

1. In affirming whether the welding wire is fed, do not peek into the small hole of current
contact nozzle. Otherwise welding wire will prick eye and face.
2. When welding wire is fed by hand or welding torch is opened, please do not put the
end of welding torch dose to eye, face and other exposure parts of the body.
1. In cutting work, the finger shall leave the nozzle and electrode on the end of cutting
torch.
2. Never make cutting work near place where parent metal is held by hand.
3. When change nozzle and electrode, please first turn off power.
1. To prevent splashing and iron powder and so on from going in the power, please
separate weld power from weld work and snagging work.
2. To prevent insulation deterioration caused by powder accumulation, please be sure to
maintain and examine and repair regularly.
3. If splashing, iron powder, etc go in the power, please be sure to turn off power switch
of welding machine and switch of distributor case, then blow off with air.
Caution: Plasma weld will result in burn, please be sure to observe the
following regulations
*Never put such any part of body as finger close to plasma work,
otherwise burn will cause.
Caution: To prevent fire caused by the deterioration of insulation of
welding power, please be sure to observe the following regulations.
* If splashing produced in welding and iron powder produced in
snagging work go in the power, the deterioration of insulation will be
produced, thus causing fire