Warn A2000, Руководство по обслуживанию

Страница: 28 / 45

28
PROBLEM POSSIBLE CAUSE CORRECTIVE
ACTION
k. Remote control switch
or cord is damaged.
Test winch operation with
replacement remote control.
Replace remote control if
defective.
l. Battery ground wire
connected to vehicles frame.
Connect ground wire
directly to negative battery
terminal.
m. Clutch housing has been
stripped due to a jerk load or use
as a tiedown.
Replace Clutch Housing
n. Drive shaft has stripped
due to incomplete engagement
Replace drive shaft
o. Sun gear has stripped
due to incomplete engagement
Replace Sun Gear
5.1.5 Winch does not have
the same pulling power as when
it was new.
a. Winch has been
submerged in mud and/or water,
and not cleaned afterwards
Clean and service as
required
b. Battery may be faulty Replace battery
c. See All possible Causes
for problem 5.1.4.
See corresponding
Corrective Actions for problem
5.1.4.
5.1.6 When remote control
switch is activated, only a
“clicking sound” results and
winch does not operate in either
power-in or power-out mode.
a. Faulty electrical
grounding.
See possible Cause a. and
corresponding Corrective Action
for problem 5.1.4.
b. Faulty battery, battery
cable or battery cable
connections.
See problem 5.1.4 Possible
Causes b. through e. and
corresponding Corrective
Actions.
c. Water in motor, caused
by submersion or improper
installation of motor.
Replace motor. See
Section 2.
d. One of the solenoids or
contactor in the control pack is
sticking or is damaged from
prolonged use.
Replace solenoid or
contactor.
e. Worn or damaged
brushes caused by damaged
armature commutator or normal
wear.
Replace motor.
5.1.7 Electrical sparks
appear around the motor or
motor end housing.
a. Water in motor, caused
by submersion or improper
installation of motor.
Replace motor. See
Section 2.
b. Burned armature due to
continued use near or at stall
speed
Replace armature