©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
6
98271A1
12. Remove factory plastic bumper trim piece (both sides).
13. Remove the wiring harness, sensors, radar (if equipped) and
any other electronic component from the rest of the bumper
shell.
NOTE: If removing vehicle rear sensors, take care when
removing as you will be reinstalling in new bumper in the
same orientation.
14. Reinstall the license plate lamp holders and trailer receptacle,
that you previously removed from the stock bumper, into
your new bumper.
15. Install factory wiring harness, sensors (if equipped) and any
other electronic component to the new WARN bumper.
Tip
: If reinstalling sensors: You will need to install in two pieces.
a. Unclip sensor from sensor retainer.
b. Insert sensor retainer through the front of the bumper.
Remember to insert in the same orientation as stock
bumper.
c. Clip sensor onto sensor retainer from the back of the
bumper., making sure it is tightly clipped (four clips).
* Sensor and receptacle shown in image may not exactly match your specific
sensor.
Figure 12
Figure 11
Figure 10
Sensor Retainer
Sensor
Trailer Receptacle
License lamp
Figure 13
Figure 14
