©2016 Warn Industries, Inc. WARN® and the WARN logo are trademarks of Warn Industries Inc.
9
98178B0
20. This is a good time to zip tie your fog lamp harnesses to any
convenient place so it will not be in the way.
Cover the end with electrical tape so dirt and debri does not
enter plug.
21. With assistance hang the bumper (A1) on the frame brackets.
22. Secure with four ½ bolts (B1), eight washers (B2), four lock
washers (B3) and nuts (B4). Refer to exploded view on page 3.
Do not tighten at this time.
Repeat for other side.
23. Insert the last remaining 7/16” hardware (just below the four
bolts just installed).
24. Make sure there is not too much space between the frame
brackets and the bumper.
The bumper should be centered from side to side on front
fenders.
25. Tighten all frame bracket hardware. Double check the frame
brackets to vehicle.
26. Check the height of the bumper from side to side and make
any necessary adjustments.
27. Tighten all bumper mounting hardware at this time.
C A U T I O N
• Always
use assistance when moving or lifting heavy parts.
(B1), (B2), (B3),
and (B4)
(B1), (B2), (B3),
and (B4)
Figure 19
Figure 20
Figure 21
Figure 22
