©2011 Warn Industries, Inc.WARN® and the WARN logo are trademarks of Warn Industries Inc.
4
88126A0
I N S T A L L A T I O N I N S T R U C T I O N S
1. In step one locate the welded puck on your plow mount.
Insert the puck into the hole as shown in figure 1. Take one
of the hex head bolts and a flat washer and insert it through
the the hole with the puck you inserted through the frame.
2. On the top side of the skid plate place the large black
washer over the bolt along with a flat washer and lock nut.
Do not tighten yet but you can take some of the slack out of
the threads. See figure 2.
3. Locate and position the RH bracket a shown in figure three
over the top of the frame. Attach to the plow mount using
two hex head bolts four flat washers and two lock nuts. Do
not tighten at this time. See figure 3.
Figure 1
Figure 2
Figure 3
W A R N I N G
IMPACT AND MOVING PARTS ENTANGLEMENT HAZARD
Failure to observe these instructions could lead to severe injury or death
•
Always remove jewelry and wear eye protection.
Read installation and operating instructions thoroughly.
