WARN® INDUSTRIES
PAGE 6
83874A0
5. With both alignment pucks seated into the plow
mount the retaining pins can be inserted. Once
inserted the retaining clips on the pins can be
clipped onto locking tab on plow mount. See Plow
operator guide “Installing the Plow” for more infor-
mation.
6. With both retaining pins secure, pull out the line
from the winch.
7. Pull the retaining pin on the plow assembly that
is securing the pulley assembly. With the pulley
assembly loose, place the pulley assembly over
the winch line and reinstall the pulley assembly
onto the push tube assembly securing the pulley
assembly with the retaining pin. See “Double Line
Rigging” in the Plow Lift section of the Plow Op-
erators Guide. Figure 9.
8. Connect the termination strap to the front bumper.
The loop of the strap should be place as high as
possible on the bumper. See Figure 8.
9. Hook the winch line to the loop on the termination
strap. See Figure 9.
10. Turn the ignition switch to ON, and operate the
winch to lift and lower the plow. The plow is now
ready for operation. Read the Plow Operators
Guide before operating plow.
Helpful Hints
When removing the plow assembly from the plow
mount, use a block under the base of the push tube
assembly to hold up the assembly at the connection
height. This will aid in the next connection on the
plow assembly.
Figure 8
Figure 7
Figure 9
