WARN INDUSTRIES
PAGE 4
80546A1
©2009 Warn Industries, Inc.
WARN® and the WARN logo are trademarks of Warn Industries Inc.
Figure 1
IV. INSTALLATION (Polaris Winch Mount)
Figure 2
Note: The Polaris winch mount (Figure 1) already
has mounting holes underneath the fairlead rollers
and does not need the adapter bracket.
1.
If using the Polaris winch mount, loosen the bolts
securing the mount to the vehicle (Figure 2) so the
winch mount is loosely attached. Remove the lower
skid pan bolts. These will not be used in this kit.
2.
Place the plow mount under the vehicle such that the
tabs fit around the frame cross bar that the lower skid
pan bolts thread into. Secure with two M8x20mm
capscrews supplied and a 13mm socket (Figure 3).
Do not tighten these.
Note: It may be necessary to line one side up first,
applying inward pressure on the skid plate
mounting tabs to fit in between the plow mount tabs
and around the cross tubing.
3.
Secure the plow mount to the winch mount. Use a
16mm socket with two M10x25mm bolts with 3/16"
flat washers (Figure 4). Do not tighten all the way.
Note: It may be necessary to rotate the winch
mount upward for the mounting holes to line up
with the plow mount holes. Make sure the lower
M8x20mm bolts are not tight, as it will make this
step difficult.
4.
Tighten the two lower M8x20mm bolts to 20 N-m
(15 ft-lbs). Tighten the two plow mount to winch
mount M10x25mm bolts to 25 N-m (18.5 ft-lbs).
Tighten the four winch mount to frame bolts to 20 N-
m (15 ft-lbs).
5.
Finally install the plow mounting tab to your Plow
Tube Assembly. Install these loosely on the plow
with the fasteners provided with the plow. Tighten
the fasteners after the plow is assembled and installed
in the mount according to the plow assembly
instructions.
Figure 3
Figure 4
