DRILL OUT THE TWO
AND FORTH HOLE
FROM THE FRONT OF
THE VEHICLE TO 3/8”.
Figure 1: Viewing from the driver’s side of vehicle, Drill out the second and forth factory holes on the
body sill. Repeat for the passenger’s side.
Once the two factory holes on each side are drilled out to 3/8”, temporarily install the appropriate rock
slider to the side of the rocker sill using six 3/8” bolts. While holding the rock slider in line with the holes in
the rocker sill, mark the sill with a pen, using the 5/16” mounting in the rear most bracket as a guide. Use
Figure 2, 3 and 4
for appropriately identifying the left and right rock slider and rear hole locations for
drilling.
Remove the rock slider and drill the two marked holes using a 5/16” drill bit.
WARN INDUSTRIES
PAGE 3
75732 A0
WARNING
Drilling operations can cause flying chips.
WEAR SAFETY GOGGLES.
Flying chips can cause eye injury.
