Warn 63290, Инструкция по установке, Страница: 4 / 5

WARN INDUSTRIES PAGE 4 63289 Rev B2
2. Plow Installation:
Slide the plow into position with the tubes under the ATV. Lift the end of the tube assembly into position
so the holes in the Tube Wings line up with the 3/8” holes in the frame brackets (Figure 3).
A Phillips head screwdriver may be used to align the holes.
Insert both 3/8” pins and hook the retaining clips on the ends of the pins to secure the plow to the ATV.
CAUTION
When using a winch with this plow, read your winch operator manual before
proceeding with this installation. ALWAYS USE EXTREME CAUTION WHILE
WORKING WITH OR AROUND A WINCH AS SEVERE INJURY OR DEATH
MAY OCCUR.
A roller fairlead must be used for lifting and lowering the plow. Cable
damage will occur if a roller fairlead is not used.
Attach the J-bolt bracket to the center hole in
the plow cross member using a 3/8”dia x 1”
long bolt as shown in figure 5. The bracket
should be mounted on the blade side of the
crossmember with the side flanges parallel to
the ground. Terminate the with a 3/8”dia
nylock nut. Tighten the bolt and nut to
recommended torque of 20 ft-lb (28 N-m).
J-BOLT BRACKET
3/8” BOLT AND
LOCK NUT
Figure 4.