Operating I nstructions - continued
Power Switch
Always turn power switch off when not in use. Permanent battery
damage may occur if the unit is allowed to self-discharge in the ON
position.
Removing the Battery Pack
Verify the Power Switch is in the OFF position.
Push down the release button at the back of the battery and
slide the battery away from the PullzAll body.
I nstalling the Battery Pack
Verify the Power Switch is in the OFF position.
Slide the battery pack in to the body, making sure that the
latch is fully engaged (
release button in the top position
).
Spooling Rope I n and Out
Do the following:
•
Always
take your time to assess your situation and plan your lift/ pull carefully.
•
Always
, prior to a lift/ pull, inspect mounting structure, the product, slings and/ or other accessories for signs of
damage. Replace damaged components prior to a lift.
•
Always
know the weight of the load and make sure the rigging, hoist, and mount will carry the weight.
•
Always
verify that the load is directly under or in line with the product, the rope is not tangled or kinked, and that
all people are standing clear of the load.
•
Always
take up any slack in the rope slowly. Begin the lift slowly. I f there is any evidence of overloading,
immediately lower the load and correct the situation.
•
Always
avoid shock loads to the product caused by rapidly lifting or bouncing a load.
•
Always
inspect and carefully rewind rope after each use. Cuts, kinks, or frayed areas reduce the strength of rope.
Replace rope if damaged.
•
Always
apply tension to the rope when spooling rope out. I f no tension is applied, the rope can ball up inside the
product, causing damage.
Avoid the following:
•
Never
use the Load Limiter to stop the travel of the load or to stop the hook against the fairlead.
•
Never
use the load limiting feature to measure the load.
•
Never
spool out rope past the length of red rope.
•
Never
attempt to lift/ pull an off-center load of any kind. This can cause the load to swing dangerously. Make sure
the load is directly under the product.
•
Never
allow the load to swing or twist.
Overloading & Overheating
The approximate PullzAll Motor effort is shown on the Load I ndicator Display (feature # 5). When the motor overloads,
the product will stop pulling and the last two bars on the display will flash red until the unit can be used again. I f this
happens, take tension off of the rope and reduce the load; do not attempt to apply the same load if the overload sensor
has tripped, as this can be harmful to the product.
I f the PullzAll will not spool in or out, verify that the Load I ndicator Display is no longer flashing and the power cord is
plugged in. Reset the Circuit Breaker and try spooling the rope. I f this does not solve the problem, contact the Warn
Customer Service department.
PAGE 8
75443 Rev. C0
