Warmtec EWN-500, Руководство пользователя

Страница: 23 / 28

23
User manual - convector heater
OPERATION
Do not turn off the device by pulling the plug out of the socket.
!
Star ng the device
Temperature regulation
The heating power switches should be set to the OFF position, then wait a few seconds and
disconnect the power cord from the socket. Turning the thermostat knob to the MIN
position does not turn off the heater. If you want to turn off the heater, use the switches.
Disconnecting the heater from the mains
Connect the plug to the power socket, the device will be in a standby mode. Set switches I
and/or II to the ON posi on. The ON posi on is the one in which the upper part of the switch
is pressed, when its lower part is pressed, it is the OFF posi on. When both switches are in
the ON posi on, the device operates at full power. If you want the heater to work at half the
maximum power, set one of the switches to the OFF posi on and the other to the ON
posi on. When the device increases the temperature in the room, the light of the on switch
is on.
If you are not using the heater, turn the switches to the OFF position.
Thermostat knob Heating power switch
MIN.
MAX.
II I
ON
OFF
The thermostat is responsible for regulating the temperature. Turning the thermostat knob
clockwise increases the temperature, turning it counterclockwise decreases it.
After switching on the device, turn the temperature control knob to the MAX point. The
room temperature will gradually increase. When the temperature in the room reaches the
desired value, turn the temperature control knob counterclockwise until you hear a click
and the switch light goes out. This will mean that the radiator has stopped increasing the
temperature in the room.