Warmtec EWN-500, Руководство пользователя

Страница: 20 / 28

20
User manual - convector heater
INSTALLATION
Faults
If the device does not heat, check that the heater is plugged into the socket, then that the
thermostat is set to the required temperature and that the power adjustment buttons are
in the on position. If you find further problems with the operation of the heater, please
contact an authorized service center.
Overheating protection
For safety reasons, the heater is equipped with overheating protection. If the air circulation
is disturbed (e.g. by covering or obstructing the air outlet grille), the device automatically
switches off. In this case, turn off the power for a few minutes (set the heating power
switches to the OFF position or disconnect from the mains) so that the heater can cool
down. Remove the cause of the overheating protection before switching it on again.
!
Any repairs outside the authorized service will void the warranty.
Assembling the feet
1. Place the heater upside down on a soft cotton cloth or carpet. Alternatively, place the
device face up on a level surface that will not interfere with the installation of the feet.
2. Attach the feet into the appropriate places at the bottom of the heater. Then fasten them
with the short screws included in the kid, using a screwdriver and tighten them.