25
User manual - convector heater
INSTALLATION
Faults
If the device does not heat, check whether the heater is plugged into the socket, then
whether the thermostat is set to the required temperature and whether the power control
knob is set to 1000 W, 2000 W or 2000 W TURBO. If you notice a problem with the operation
of the heater, contact an authorized service center.
Overheating protection
For safety reasons, the heater is equipped with overheating protection. If the air circulation
is disturbed (e.g. by covering or blocking the air outlet grille), the device automatically turns
off. In such a case, turn off the power for a few minutes (set the power control knob to
position 0 or disconnect from the power supply) to allow the heater to cool down. Before
turning the device back on, remove the cause of the overheating protection.
!
Any repairs outside the authorized service center will void the warranty.
Installing the feet
1. Place the heater upside down on a soft cotton cloth or carpet. Alternatively, place the
device face up, on a horizontal surface that will not hinder the installation of the legs.
2. Attach the legs with the short screws included in the kit, using a screwdriver and tighten.
0
