29 March 2021
Due to continued product improvement, Warmington Ind LTD reserves the right to change product specifications without prior notification.
All Dimension are in mm
………….
Copyright ©
13
COALS AND LOGS (To be set by Gasfitter)
Gloves should be worn when handling Ceramic Fibre Coals & Logs.
The carbon on the coals can stain the surroundings.
HELPFUL HINT: Use metal tongs when HOT.
Apply a thin layer of Vermiculite over the Burner, just enough to cover the Burner tray only as shown above.
1 : Bottom Row
: Assemble 2 bottom rows of coals onto the Vermiculite base.
2 : Top Row
: Assemble 2 top rows of Coals onto the
bottom row.
•
Each Coal randomly positioned with the Torn (roughest) Face Outward
Ensure Coal positioning does not directly block the 3 Flame Pilot .
•
The placement of the Coals & Logs may vary to make an even flame pattern.
•
Logs and twigs may be scattered to achieve best visual effect.
•
Fit Burner grate by sliding R & L side metal pins on grate, into holes located on burner side plates, as shown below.
2: Top Row
Slide R & LH Grate
Pins into Holes locat-
ed on the Burner Side
plates .
1: Bottom Row
Model SG780 Shown: Total number of coals will vary per mod-
General Coal orientation fro optimum effect.
APPLYING THE VERMICULITE:
(Coarse
-
must be larger than the burner plates holes so not to block them)
Apply with care a thin layer of Vermiculite over the Burner, just enough to cover the Burner Tray only .
NOTE: If the burner flame is uneven, the Vermiculite may need to be changed or sifted to remove the smaller pieces that can block the burners
holes. The smaller pieces can ,cause uneven burn and the unit to run dirty.
Total Coals
Bottom
Top
Bottom
Top
Model
Total
SG / EG 700
6
5
2
2
22
8
6
2
2
SG / EG 780
28
SG / EG 900
10
9
2
2
38
SG / EG 1100
11
10
2
2
42
SG / EG 1250
16
14
2
2
60
Number of Coals per
Number of Rows
VERMICULITE (COARSE) (To be set by Gasfitter)
