www.Warming-Trends.com | 303 346 2224 | [email protected]
19
4. Test without Gas
Test Spark Igniter and Push
Button Module WITHOUT gas,
making sure spark arcs from
electricity to jet.
5. Test with Gas
Burner should light within 5
seconds or a few clicks.
2. Install Push Button Module
into Mounting Bracket
Unscrew Button Cover.
Remove plastic Nut.
Insert Washer #1 onto the
button stem.
Insert Push Button Stem
through mounting bracket
hole.
Insert Washer #2.
Put on plastic Nut and turn
until Push Button Control has
been secured to mounting
bracket.
Insert AAA Battery into Button
Stem.
Screw on Button Cover.
Push Button
Module
Key Valve
Button Stem
Washer #1
Washer #2
Nut
AAA Battery
Button Cover
Mounting Bracket
3. Connect Spark Igniter Wires
Crimp Spark Igniter Wires,
then slide crimped wires on
to connections using needle
nose pliers. Be careful not to
break connectors. Wires can
go in either connection.
Push Button
Module
Spark Igniter
Wires
Key Valve
Mounting Bracket
Jet
Drill
Here
Spark
Igniter
Stem
.125”
Plate
CROSSFIRE
Brass Burner
PUSH BUTTON IGNITION SYSTEM
CONNECTION DIAGRAMS
Up to 300K BTU Systems
1. To place the Spark Igniter in the
proper position, installer will
need to drill a hole in the plate.
Measure where to drill hole by
holding tip of Spark Igniter no further
than .125” away from inside edge
of jet. Drill hole where base of spark
igniter sits. Thread wires through
drilled hole and pull until Spark
Igniter bracket is in place on plate.
Screw Spark Igniter to plate.
If the distance to the jet is greater than .125”, you can adjust the position by
gently
bending the spark ignitor by the stem.
%HQGLQJWRRIDUFDQUHVXOWLQEUHDNDJH'RQRWŴH[DWWKHH[LVWLQJEHQGWKLVFDQUHVXOWLQEUHDNDJH,IWKHVSDUNLJQLWRULVWRR
far away or too close to the jet, you will not get a strong enough spark to light the burner.
