Warmhaus RecoWa, Руководство по установке и инструкция пользователя

Страница: 11 / 28

11
warmhaus.com
Figure 8. Combi Boiler Control Unit Main Board Connections
Figure 9. Installing Batteries into the Room
Thermostat Unit
7.4.3. Installation of the Room Thermostat
Unit and Installing the Batteries
Open the battery compartment cover on
the back of the Room Thermostat Unit,
insert two 1.5V AA Alkaline batteries
into the battery compartment, paying
attention to the + and - poles, and close
the lid. When the batteries are inserted
for the first time, the backlight turns on
and all symbols appear for a short time.
The ambient temperature will then appear
on the display and it will automatically
connect to the Combi Control Unit/RF
MODULE.
When the Room Thermostat Unit is
MAINBOARD SCHEMATICS OF
THE RECOWA COMBI CONTROL
1) Thermostat control switch (Enabled / Disabled)
2) On/Off control communication cable (Brown)
3) OpenTherm combi boiler communication cable (Red)
4) Power cable (230V AC ~50Hz )
5) Transformer (230V AC to 6V AC)
6) Factory reset button
7) RF antenna
8) LED light
9) Relay
1
Combi
Boiler
2
3
4
5
6
8
7
9
RED
BROWN
POWER CABLE
(230V AC 50Hz)
Alkaline Battery
(2 x 1,5V DC)
Battery
Compartment
Cover
connected to the RF MODULE, the signal
symbol
will appear on the screen. The
Room Thermostat Unit is now ready for
use. You can adjust the room temperature
using the + and – buttons on the unit.
For the proper and efficient operation of the room thermostat, please use
alkaline batteries. Never use rechargeable batteries. It has a special protection
measure against the reverse installation of the batteries.