WarmFlow Cylinder Passport, Инструкция пользователя, Страница: 8 / 16

5 GUARANTEE REGISTRATION
To qualify for the product guarantee the equipment MUST be correctly commissioned, the below Guarantee Registration
completed and returned to the manufacturer as instructed, along with proof of purchase.
FAILURE TO COMMISSION AND REGISTER THE PRODUCT MAY INVALIDATE ALL GUARANTEES.
Installation
Tick or insert value
1 Is the installation in a hard water area (above 200mg/litre) Yes
(tick)
No
(tick)
If yes, has a suitable and effective hard water treatment been fitted? Yes
(tick)
What type of hard water treatment has been fitted?
2 What is the incoming static cold water pressure on the mains supply?
bar
3 Where in the property is the inlet group situated?
4 To what pressure is the pressure reducing valve on the inlet group set?
bar
5 Has the expansion vessel bladder pressure been checked (prior to system filling)? Yes
(tick)
6 What is the expansion vessel bladder pressure?
bar
7 Has the factory-fitted temperature & pressure relief valve been correctly piped to a suitable discharge? Yes
(tick)
8 Has the expansion valve of the inlet group been correctly piped to a suitable discharge? Yes
(tick)
9 Is the discharge arrangement piped and terminated in accordance with Building Regulations? Yes
(tick)
10 Has the discharge arrangement from the expansion / temperature & pressure relief valves been tested? Yes
(tick)
11 Have all pipes been insulated up to 1 metre from the cylinder, or to where they become concealed? Yes
(tick)
Controls
12 Have time & temperature controls been fitted in accordance with Building Regulations? Yes
(tick)
13 What type of control system has been fitted? S-plan
(tick)
Y-plan
(tick)
Other
(tick)
14 Are all heat sources wired through the correct cylinder / immersion limit thermostat(s) Yes
(tick)