Warm Tech CAC20KW, Оригинальное руководство пользователя

Страница: 42 / 67

42
CAC30KW / CAC50KW : following accessories are supplied in the shipping carton.
Fig.2
To assemble the heater, proceed as follows (see Fig. 2):
1
、
insert the wheel shaft J to the corresponding hole of feet pipe E
，
insert the cotter
K to the corresponding holes; put plain washer I to the two sides of shaft,
slide the
wheel H over the wheel shaft J
，
screw the nut G to fix the wheel on the shaft.
2
、
Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A
point towards the corresponding 4 holes on the feet pipe respectively.
3
、
Using the screw B ,spring washer C, plain washer C and nut 4 to fix the feet pipe
assembly and handle to the tank.
5. INSTALLATION INSTRUCTIONS
Position the heater on a flat, level, non-
flammable, solid surface.
Direct-fired heaters are intended for use in
outdoor open areas or in indoor well
ventilated areas. For indoor use, provide
permanent ventilation openings of at least 25 cm²/kW, equally
distributed between floor and high level, with a minimum of 250 cm².
Pos. Description Qty
A Handle 1
B Screw 8
C Spring washer 8
D Plain washer 8
E Feet pipe 1
F Nut M5 8
G Nut M12 2
H Wheel 2
I Plain washer ø12 2
J Wheel shaft 1
K Cotter 2
CAC20KW CAC30KW CAC52KW
Minimum Opening Size 600 cm² 800 cm² 1250 cm²