Warm Tech 5411074212889, Оригинальное руководство пользователя

Страница: 42 / 56

42
4. ASSEMBLING INSTRUCTIONS
Extract the heater from its carton. If the unit is anyhow damaged, do not use it and
contact your dealer.
The following accessories are supplied in the shipping carton.
To assemble the heater, proceed as follows (see Fig. 1):
1
、
Insert the wheel shaft K to the corresponding hole of feet pipe B
，
insert the cotter
J
to the corresponding holes; slide the wheel I over the wheel shaft
K put plain
washer H to the two sides of shaft,
，
screw the nut G to fix the wheel on the shaft.
2
、
Put the heater body on the feet pipe assembly, make sure the 4 holes of handle A
point towards the corresponding 4 holes on the feet pipe respectively.
3
、
Using the screw F ,spring washer E, plain washer D and nut C to fix the feet pipe
assembly and handle to the tank.
5. INSTALLATION INSTRUCTIONS
Position the heater on a flat, level, non-flammable, solid surface.
Direct-fired heaters are intended for use in outdoor open areas or in
indoor well ventilated areas. For indoor use, provide permanent
ventilation openings of at least 25 cm²/kW, equally distributed between
floor and high level, with a minimum of 250 cm².
Pos. Description Qty
A Handle 1
B Feet pipe 1
C Nut M5 10or1
2
D Plain washer 10or1
2
E Spring washer 6or8
F Screw 10or1
2
G Nut M12 2
H Plain washer ø12 2
I Wheel 2
J Cotter 2
K Wheel shaft 1
CAC80KW
Minimum Opening Size 2000 cm²