3
17. Do not fill above MAX FILL line for blending.
18. Not for waterjet cleaning.
19. Ensure the jar coupler and motor coupler are aligned and
engaged before operating. If unable to engage, remove jar
and shake contents, then try again.
20. The jar coupler and motor coupler may be hot after running;
do not touch.
21. Replace jar pad if worn.
22. Always use HIGH speed for crushing ice.
23. If the jar overflows during blending, there is too much
liquid/ingredients in the jar. Stop blending, remove
enough liquid/ingredients to below MAX FILL line, and
continue blending. Do not operate if overflowing.
24. DO NOT use carbonated liquids in the blender jar or any
blending container. Using carbonated liquids in the blender
jar or any blending container may result in injury.
25. DO NOT blend oil or oil-based products such as peanut
butter for more than 5 minutes.
26. Never remove blender jar from base unit until the blade and
coupling have completely stopped.
27.
CAUTION:
In order to avoid a hazard due to inadvertent
resetting of the thermal cutout, this appliance must not be
supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on
and off by the utility.
SAVE THESE INSTRUCTIONS
GROUNDING INSTRUCTIONS
• For your protection, Waring
®
Commercial Blenders are
equipped with a 3-conductor cord set.
• 120 volt units are supplied with a molded 3-prong grounding-
type plug and should be used in combination with a properly
connected grounding-type outlet, as shown in Figure 1.
If a grounding-type outlet is not available, an adapter, shown in
Figure 2, may be obtained to enable a 2-slot wall outlet to be
used with a 3-prong plug.
Referring to Figure 3, the adapter must be grounded by attaching
its grounding lug under the screw of the outlet cover plate.
