MX1100XT OPERATION
Follow steps 1-3 in the MX1000XT Operation section.
1. This blender is equipped with an electronic
membrane keypad. The keypad has a main power
On/Off button, plus High, Low, Stop and Pulse
buttons and a 30-second countdown timer with Up
and Down arrows to set time.
2. Press the On/Off button to turn on the blender.
Green LED will illuminate. The electronic timer will
indicate 10 seconds (default). Press the Up or Down arrow to set the
desired time. The electronic timer will indicate run time in 5-second
intervals up to a maximum of 30 seconds. After the desired time is set,
press High or Low to start the blender. The timer will count down to
0 in 1-second intervals and blender will shut off. Pressing the Pulse
button, the Stop button or the On/Off button will override the timer and
the blender will stop regardless of time left on timer.
NOTE:
If you want to increase or decrease time while timer is counting
down, press Up or Down arrows. Time will increase or decrease in
5-second intervals.
3. If the blender is not used for five seconds, the timer function will turn
off and return to manual mode. To reactivate timer, press Up or Down
arrows. When using the electronic timer again, the initial time will be the
last time set.
Note:
If unit has been turned off or unplugged, the timer
will default back to 10 seconds.
4. For continuous operation, press either Low or High button. When
finished blending, press Stop. For momentary operation, press the
Pulse button. Motor will run on high speed until the button is released.
NOTE:
Your MX1100XT utilizes a Slow Start
™
feature. When pressing
High, the unit will start in the low speed for 2 seconds and then switch
to high speed. This allows for a more even blending of ingredients in
container.
5. Allow motor to come to a complete stop before removing container
from blender base. Never place the container on the motor base or
remove it from the motor base while motor is running.
6. Wash and dry container after each use. See Cleaning and Sanitizing
Instructions.
7. To turn the unit off, press On/Off button. Green LED light will go off.
RESETTING THERMAL PROTECTION
•
Your blender is equipped with an automatic reset switch to protect the
motor from overheating.
• If your blender stops running under heavy use, press the power switch to
Off and unplug the power cord. Empty the blender container of all its
contents and allow approximately 5 to 10 minutes for the motor to cool
down.
• Plug the power cord back into the outlet and continue blending.
• If your blender does not function properly following this procedure,
discontinue use and contact a certified Waring Customer Service Center.
5
