WAREMA Wisotronic, Руководство по установке

Страница: 33 / 108

warema_890558_alhb_en_v5•2022-02-01 We reserve the right to carry out improvements
33
Overview
The header is visible in all menu levels. The date and time are shown at the
top (
A
). Various symbols are shown between the date and time, depending
on the state of the Wisotronic (
B
, Chapter 6.1.1 ). Below this, the menu in
which you are currently located ( C ) is identified.
The currently measured weather data of the sensors (
D
) appear in the
display field
below this. In addition, you will see whether you have activated
the Automatic features ( E ) and whether the "Absent" switch has been
pushed on the control panel ( F ).
The footer (
G
) always shows which functions the four buttons below it cur-
rently have.
The following functions are assigned to the buttons in the start menu:
The [
Main
] function button leads to the main menu, where you can access
scenes, channels and groups. With the [
Auto
] button, you can switch the
automatic modes of the Wisotronic on and off. The [
Absent
] button is used
to activate the Absent function. The [
Meas. val.
] function button takes you
back to the start menu, where the measurement values, causes, malfunc-
tions and histories are displayed. Histories are graphic presentations of the
chronological sequences of measured values that can be conveniently traced
with the cursor.
6.1.1 Status display
The symbols in the header indicate the following states of the Wisotronic:
Data must be loaded into the devices
Service mode
A fault occurred. Fault messages are displayed in the fault menu
([
Start menu
] > [
Measured values
] > [
Faults
]).
"Leave" function is activate
"Absent" function is active