Introduction
2029839 [Rev. 3 - en]/2019-03-22
Page 5 | 24
Operation in winter (product with control system)
Products operated by means of a control system may start
moving at any time and without prior notice. Moisture on
the product due to dew, rain or snow can cause the product
to freeze up at low temperatures. Operation of the product
may cause damage.
When using a control system without an ice alarm, the
automatic function should be switched off in winter.
Malfunction due to leaves or foreign objects
External sun shading systems are exposed to weather
and environmental influences. Depending on the location,
leaves and other foreign objects can cause the product to
malfunction.
Remove leaves and other foreign objects from the
beams, the inspection openings for the integrated
awnings and the awning fabrics.
Special feature of fabric (if present)
Fabrics can become electrically charged. Contact with
people or objects may result in an electrostatic discharge
from charged fabric.
Risk of damage to the product
An additional load can damage the product and/or cause it
to detach from the wall.
Do not hold onto the product or hang any objects on it.
It is not permitted to step on the product.
soiled drainage (for slat roof)
Gutters may clog with leaves, moss and dirt. This may
cause the gutters to overflow when it rains.
Gutters without or with an insufficient gradient must be
inspected and cleaned more frequently.
2
Product information
2.1
Intended use
The following details apply to the following product: slat roof
Lamaxa L60/L70
The product is a weather-proof, large-area external sun
shading system that may be used for protection against
heat and rain and for glare control. The product is used to
shade residential and commercial areas.
The rotatable slats can be used to reduce or prevent direct
sunlight from the top.
When closed, water is drained to one side via the slats and
is directed to the poles via the drainage gutter.
Inappropriate use may result in significant danger.
All closures and awnings for external use are designed for a
wind load of 1.1 kN/m² when in a retracted state.
The directive entitled "Wind loads for construction of
closures and awnings when retracted – Section 5.1.1"
defines the positions at which these products can be
installed without requiring special precautions [published
by the Bundesverband Rol Sonnenschutz e. V. and
ITRS Industrieverband Technische Textilien - Rollladen -
Sonnenschutz e. V.].
Additional loads on the product in the form of hanging
objects or ropes/cables could damage the product or cause
it to become detached from the wall and are therefore
not permitted. WAREMA will not be liable for any ensuing
damage.
The intended use also includes observing these instructions
and adhering to the service requirements they describe.
Optional:
Integrated awning with easyZIP guidance
The product is an external textile sun shading system that
may only be used for heat protection, glare protection
and visual privacy on vertical glass surfaces. The product
reduces the incidence of light and optimises the use of solar
energy.
The product is intended to be used to protect against the
sun, not the rain.
Optional:
LED strips
The product is an electronic LED lighting device (warm
white light) for outdoor installation.The product can only
be run on a 230 V~/50 Hz mains voltage if the supplied
transformer is used.
Optional:
Radiant heater
The product is designed to generate radiant heat outdoors
that emulates the sun. The product is connected to a mains
voltage of 230 V/50 Hz via the WMS Plug receiver power.
