890463_k•en•2019-10-01
We reserve the right to carry out improvements
4
Learning in the weather station
The weather station sends wind- or brightness-related
move commands to an EWFS receiver. It must be learned
into the receiver first.
IUTCCE
O
The weather station must be charged before
commissioning to enable fault-free operation
(see Commissioning). The weather station can
only be learned in as an auxiliary channel.
CExample:
You would like to operate an external venetian
blind with a 1-channel hand-held transmitter (I) and control
it with the weather station based on brightness and wind
values.
1
Ι
= Master channel
= Auxiliary channel
Fig. 9 Controlling a external venetian blind with a hand-held
transmitter (I) and a weather station.
Perform the following steps consecutively:
Place receiver 1 into learn
mode:
Perform the power-
up procedure on external
venetian blind 1.
Learn in the hand-held
transmitter (T) as the master
channel:
Take the hand-held
transmitter (I), press and hold
the learn button, the external
venetian blind 1 waves once,
release the button.
The learn mode is ended
automatically. The hand-held
transmitter (I) is now the
master channel for external
venetian blind 1.
External venetian blind 1 can now be operated with the
hand-held transmitter (I).
Now learn the weather station into the receiver as an
auxiliary channel:
For this function, the wind
speed limit may not be set to
TEST and the brightness limit
value may not be set to OFF
at the weather station.
Place receiver 1 into learn
mode:
Take the hand-held
transmitter into which the
master channel was just
learned (I), press and hold
the learn button, external
venetian blind 1 waves once,
release the button.
Ι
Ι
Learn in the weather station
as an auxiliary channel:
Press the
button on the
weather station and hold it
until the sun shading system
stops moving (the external
venetian blind waves twice).
Release the button. The
weather station is now an
auxiliary channel for external
venetian blind 1. The wind
and brightness evaluation
was learned in at the same
time.
CEnd the learn mode:
Take
the hand-held transmitter with
the master channel (I) and
press the "Up" or "Down"
button.
External venetian blind 1 now can also be controlled
with the weather station.
The weather station evaluates the brightness and
wind speed data and controls the sun shading system
accordingly.
Uesting the weather station
Perform the following steps to test the functions of the
weather station.
In the previously described learning procedure, the wind,
precipitation and photo sensors were learned in together.
If you discover during the test that one of the sensors was
not learned in (e.g. due to electromagnetic interference), it
must be learned in again
separately
.
IUTCCE
O
If a sensor that has already been learned in is
learned in again, it is learned out.
CExample:
During the learning procedure, only
the wind sensor was learned in. If the learning
procedure is repeated, the photo sensor is
learned in but the wind sensors is learned out
at the same time.
1. Uest the wind monitoring function
Move the "Wind" switch on the weather station to the
TEST position. Move the sun shading system down
slightly and cause the wind wheel to turn rapidly. The
sun shading system should now move up as a wind
alarm is triggered. The sun shading system now cannot
be operated for the duration of approx. 1 minute (wind
alarm).
IUTCCE
O
In the TEST position, the duration of the wind
alarm is only approx. one minute, after which
the system can be operated again. For all other
settings (see the adjacent limit value table) a
wind alarm takes approximately 10 minutes.
The TEST setting should not remain set during
normal operation since the weather station
otherwise continuously sends a wind alarm
(high power consumption).
Ι
