Wardrobes Online Maxi Wall Hung Series, Руководство по установке

Страница: 10 / 10

INSTALLATION INSTRUCTIONS
HANGING RAILS
1. For Top Height Rail: Measure 300mm from the back of the tower/wardrobe panel.
From that mark measure 50mm down and mark with a pencil. If you are measuring from underneath a top shelf
bracket, measure down 40mm from the bottom of the shelf bracket (this allows 10mm for the bracket).
Install wall plugs where required for a stronger install.
Screw the silver bracket into the wall.
For Mid Height Rail: Measure 300mm from the back of the tower/wardrobe panel.
From that mark, measure 1000mm down from the top-height-rail.
Note: because floors are sometimes not level we recommend you check heights and levels as you proceed through
the installation process
2. Measure the length between the installed rail brackets to get your rail length.
*Tip allow 2.5mm for each rail end, so a 600mm wide gap between two walls you would cut the rail at 595mm
3. Mark on rail your measured length and cut the rail using a hacksaw (we recommend a minimum of an 8pt saw).
Once cut, slot rail into rail brackets.
50mm
300mm
40mm