4.
On one of the side panels, slot the 4 fixed shelves into the cam pins. Ensure the white edge of the shelf is at the
front of the tower, and that the cams are facing the floor (as shown).
Once the shelf is in place, tighten the cams with screwdriver. Be careful not to overtighten.
5.
Once all cam pins for shelves and/or drawer runners have been installed on both side panels, lower the second
side panel into place where Cam Pins meet with fixed shelf Cams. Screw Cams to tighten.
6.
Stand tower upright.
If your system has drawers, install your drawers by angling the drawer upwards (as shown) and lower and level
the drawer as you slide it in. See Drawer Assembly for more information.
For drawers to operate correctly, make sure the wardrobe tower is on a level surface and square to the back wall.
If the floor is not level then floor packers may be required (not included).
7.
Now your tower is fully assembled, position the tower in place in your wardrobe and secure to the wall using the
Econo Brackets (pictured). Where possible, fix brackets into studs, or if studs are not available use the Wall Plugs
provided. Use a 5mm drill bit. If your system has drawers – it is recommended to secure Econo Brackets under
the shelf above the top drawer, this will be hidden at the very back and will help your system stay square for
efficient drawer operation.
