7.
Stand tower upright.
Insert Adjustable Shelves at your desired heights using the Adjustable Shelf Supports.
If your system has drawers, install your drawers by angling the drawer upwards (as shown) and lower and level
the drawer as you slide it in. See Drawer Assembly for more information.
For drawers to operate correctly, make sure the wardrobe tower is on a level surface and square to the back wall.
If the floor is not level then floor packers may be required (not included).
8.
Now your tower is fully assembled, position the tower in place in your wardrobe and secure to the wall using the
Econo Brackets (supplied). Where possible, fix brackets into studs, or if studs are not available use the Wall Plugs
provided. Use a 5mm drill bit. If your system has drawers – it is recommended to secure Econo Brackets under
the shelf above the top drawer, this will be hidden at the very back and will help your system stay square for
efficient drawer operation.
Once in place, close the cap cover to conceal the screw.
9.
Next you will need to cut and install your top shelf and hanging rails.
Refer to Top Shelf Installation and Hanging Rail Installation for information about installing these into your
wardrobe.
300
