Wanner Engineering Vector 2000 Series, Инструкция по установке и эксплуатации

Страница: 3 / 16

3
Wanner Engineering, Inc.
Material Operating Temperatures
Material Operating Temperatures
EPDM 32 to 185˚ F
Hypalon 32 to 180˚ F
Neoprene 50 to 130˚ F
Silicone 14 to 185˚ F
Varprene 14 to 185˚ F
Natural Rubber 14 to 185˚ F
Nitrile Rubber 23 to 160˚ F
Pharmed
®
32 to 180˚ F
United States Instant Information: www.vectorpump.com
(612) 332-5681 Fax (612) 332-6937 VEC-991-2400E
Vector 2000 Series Installation
Pump Test and Installation
Before you install the pump in the system, set the direction of
pump rotation and the position of the pressure rollers:
1. Remove front cover from pump.
2. See Figure 1. For easier adjustment, check that pressure
rollers are in position shown (one roller compressing middle
of hose, and one roller free).
Note: Model 2006 and 2007 pumps use a different rotor
assembly than the one shown.
Before Initial Start-Up
Before you pump fluid through the system, be sure that:
1. All shutoff valves are open.
2. All connections are tightly secured.
3. See Hose Identification Table. Hose material is compatible
with fluid being pumped, and hose design matches duty cycle
and discharge pressures.
Hose Id entification
Extruded Code Description
Hypalon HE Black color, shinny smooth surface
Neoprene PE Flat black color, rough surface, rubber
smell
Varprene VE Cream color, smooth surface
Silicone SE Rust color, smooth surface
Pharmed
®
FE Cream color, Pharmed
®
name on hose
Fiber Braided
Hypalon HF Black color, yellow or blue stripe, double
braided
EPDM EF Black color, white stripe, double braided
Natural Rubber NF Black color, green stripe, double braided
(standard duty)
Natural Rubber MF Black color, no stripes, thick double
braids (heavy duty)
Nitrile Rubber BF Black color, white inner hose
Nitrile Rubber - Oil Rated OF Black color, HBRF-HY-K stamped on
hose
W0455
W0456
Pressure
Rollers
Figure 1
W0456
DISCHARGE
INLET
Figure 2
3. Connect incoming power supply to motor (refer to motor
manufacturer’s instructions).
4. See Figure 2. Run pump and check direction of rotation,
“A” or “B” as shown. All pumps must rotate in direction “A“
(counterclockwise). To reverse rotation, exchange two of three
wires that connect incoming power to motor.
5. Set pressure rollers (see “Service: Setting the Roller
Pressure”). Roller pressure is not set at factory, because it
must be adjusted to compensate for size of inlet and discharge
lines and specific gravity of fluid being pumped.
6. Verify all fasteners are properly tightened.
7. Reattach front cover.
8. Install pump in system.
4. See Material Operating Temperatures Table. Temperature of
fluid pumped is within operating temperature range of hose
material installed in pump. Hose material can be identified by
5
th
and 6
th
digit of pump model number. E.g. 2007-NF-BB-D2,
where ‘NF’ designates natural rubber.
CAUTION
: Contact factory when pumping a fluid that is
within 15˚ F of the maximum hose temperature. Take safety
precautions to insure hot pumpage does not harm operators
if a hose leaks.