WANHAO DUPLICATOR I3 MINI, Инструкция по эксплуатации, Страница: 5 / 38

Safety Instructions
Before you get started, please read these important safety instructions.
CAUTION : The WANHAO 3D Printer generates high temperatures and includes moving parts
that can cause injury. Never reach inside of the WANHAO 3D Printer while it is in operation,
and allow time for the printer to cool down after operation.
HOT SURFACE
MOVING PARTS
Vapours/fumes may be irritating at operating temperatures. Always use the WANHAO
3D Printer in an open, well ventilated area.
Do not leave the WANHAO 3D Printer unattended during operation
Contact with extruded material may cause burns. Wait for printed objects to cool before
removing them from the build platform.
Always take care when using the Scraper. Never direct the Scraper towards your fi ngers.
• The printer must not be exposed to water or rain, or damage will occur.
• The printer is designed to be used with ambient temperature ranging 15°C - 30°C, and humidity
ranging 20% - 50%. Operating outside these limits may result in low quality models.
• In case of emergency, turn off the 3D printer at the power outlet.
• It is recommended that you use eye protection when cleaning/sanding printed models to avoid
small particles contacting eyes.
• Please read and understand the contents of this installation and user manual carefull.Failure to
read the manual to make the most out of the WANHAO 3D Printer.
• The WANHAO 3D Printer is not intended for use by persons with reduced physical and / or
mental capabilities, or lack of experience and knowledge,unless they have been given
supervision or instruction concerning the use of the appliance by a person responsible
for their safety.
• Children should be under constant supervision when using the printer.
• Before installation ,you should make sure that the WANHAO 3D Printer is unplugged from the
power supply. Only use furniture that can safely suppport WANHAO 3D Printer.
• Ensure the mains socket-outlet is near the equipment and is easily accessible.
5
Only use the WANHAO 3D Printer in a clear working area.