- 24 -
Changing of gear oil
（
Fig.25
）
The recommended engine oil:
SAE 80W/90
Oil
capacity
Resolving capacity:0. 11L
Changing capacity:0. 1L
•
Park in Main Stand
。
•
Take apart the limiting bolt (2), and the spilling bolt (1).
NOTICE: The engine must be warmed up when spilling and the vehicle must be support
by main stand!
Reinstall the spilling bolt after clean. And screw up.
Inject 100ml to engine through immix bolt
•
Install immit bolt and screw up.
Spark plug(Fig 26)
The specification of spark plug
Standard: C7HSA
（
NGK
）
,A7T,A7RT
Fig25
Fig26
- 25 -
Take apart the spark plug; Take it of with special tool.
Examine if there is dirty on poles and the porcelain head in center .If it has
corroded, must change it .It is the best way to clean with the liquor of spark
plug Use wire brush if no cleaner.
Normally the gap between side electrode (1) and Center electrode (2) is
0.6-0.7.
•
Don
’
t use other spare plug.
Fuse replacement
The specified electric current of the total fuse is 15 A
If the connection is not good, the fuse will overheat and breakdown.
Do not use any fuse whose specification is different from assigned. It is the same
Main reason of wiring burning.
NOTICE: Do not use brass wires to replace the recommended.
V.
Vehicle Storage
Storage
For the motorcycle not to be used for a long period of time, for example, in wintertime, some
steps should be taken to prevent malfunction of and damage to its components, which might be
caused by long storage. Besides, before the long storage, proper maintenance has to be carried
out for fear that it might be forgotten when vehicle is put back into use after storage.
1.
Change engine oil and oil filter.
2.
Drain off fuel from the fuel tank and carburetor, spray atomized anti-rust oil onto the inside
wall of the tank and then close the tank.
