WANDERS Olaf Eco, Руководство пользователя и инструкция по установке

Страница: 19 / 64

19
GB
The stove will become very hot when you
light it and will need at least a couple of hours
to cool off. Don’t touch the stove without
protection during firing and during cooling
off. Handle the stove always with a glove to
avoid getting serious burns.
Before lighting the fire, you must clean away any
deposits on the window pane with a piece of paper
towel. The same paper can be used for lighting the fire.
Open the combustion air inlet
d
. Open the slide to its
maximum before lighting the stove. Open the flue gas
regulator in the flue duct
c
. Then open the door and
put some balls of paper or firelighters in the stove and
place some wood kindling on top. Light the kindling
and leave the stove door ajar (for 3 to 5 minutes) for
extra air supply and enhancing chimney draught. Once
the kindling has caught fire you can add extra wood.
(Put the logs loosely on the fire so that the flames can
catch on all around). Close the flue gas regulator once
the stove has the right temperature
c
.
The flue gases are then guided along the soapstone on
the inside.
Reloading wood
To prevent fumes from entering the room while reloading the wood make sure to open the regulator
in the flue duct first. After you’ve closed the door you can close the regulator again.
Air valve
The air valve
d
has 3 positions:
1. Opened all the way: the primary and secondary air supply is open.
2. Pressed until the first click is heard: only the secondary air supply is open and the stove will produce the
highest yield while the glass cleaning system works optimally.
3. Pressed until the second click is heard: everything is closed, and the fire will go out slowly.
It is prohibited to light the stove with liquids like petrol or spirits. Do not have the cooker hood on in
the room where you operate your stove.
Never touch the varnished parts when you heat your stove.
Lighting the stove for the first time
Newly-built house or recently renovated?
It is advisable to wait six weeks before lighting the stove in a newly-built house that has recently been completed, or in
a space that has recently been renovated drastically. The walls and ceilings still contain gases, softeners and moisture
from plasterwork or paint. The warm air-streams may discolour the dust particles in the space which may stick to
walls and ceilings. Even the moisture in the walls and ceilings will become warm and may cause yellow stains.
Anneal procedure for soapstone
The warranty does not cover any damage caused by not complying with the anneal procedure set out below.
The stove is only suitable for burning wood. Please see the chapter on ´Fuel´ on page 20.
t
Open the air valve
d
!
!
c
d
!
!