WANDERS Lenga 500, Инструкция по установке, обслуживанию и эксплуатации

Страница: 5 / 36

5
Installation, Servicing and User Instructions | EN
• As this is a room sealed appliance and the appliance stands on appropriate legs, a hearth is not required for
this appliance.
• The Fireplace should be ventilated with openings giving a total free vent area of 200 cm².
• A gap of 50mm should be left all round the appliance.
• If a shelf is to be fitted above the fireplace opening, a gap of 150mm minimum should be left between the
opening and the shelf.See section 3.3.3, Mantel Clearances.
• The brackets supplied may be used for securing the appliance to a rear wall.
3.3.1 Building the Fireplace
• Construct a studwork fireplace to the desired sizes, minimum sizes are shown in section 3.3.2. Any combustible
material used to construct the Fireplace must not be closer than the minimum dimensions quoted in section
3.3 above. Cement Board of minimum thickness 12mm, can be used as a Thermal Break and can be used
directly against the Frame Face on the appliance.
• Do not use insulation material (or other) to pack the void around or above the appliance.
• Provide ventilation from the fireplace to the minimum amount quoted in 3.3 above.
• Provide a cut-out for the Control Access Door.
3.3.2 Built-In Fireplace Sizing
(assuming a Cement Board Lining is used)
Appliance
A
min
B
min
C
min
D
min
E
min
F
min
G
min
H
min
Lenga 500 A 552 905 655 415 195 1235 n/a n/a
Lenga 500 ABC n/a 905 600 415 195 1235 290 n/a
Lenga 500 AB/AC n/a 905 640 415 195 1235 290 505
Lenga 800 A 852 755 955 415 195 1083 n/a n/a
Lenga 800 ABC n/a 755 900 415 195 1083 290 n/a
Lenga 800 AB/AC n/a 755 940 415 195 1083 290 805