19
GB
Switching from ºC/24-hour to ºF/12-hour indication
t
Press the
OFF
button
e
and the small flame button
d
simultaneously (2 sec) to switch from ºF (and the
12-hour indication) to the ºC (and the 24-hour indication), and vice versa.
Possible settings
t
By pressing the
SET
button
f
you can switch quickly between
MAN
Â
day temperature
Â
night tem-
perature
Â
timer
Â
MAN
.
t
MAN
: this setting allows you to turn the flames manually higher or lower with the big-flame button
c
or
the small-flame button
d
.
t
Day temperature
(
): this mode allows you to set the desired daytime temperature; the remote control
set will function as a thermostat.
t
Night temperature
(
e
): this mode allows you to set the desired night temperature.
t
TIMER
: this mode allows you to preset 2 switch-on and 2 switch-off times per 24 hours. If the night setting
is on - - -, the stove will burn on the pilot flame.
Setting the temperature
t
Select the day temperature or night temperature by briefly pressing
SET
button
f
.
t
Now press
SET
button
f
longer until the display starts flashing.
t
Preset the temperature with buttons
c
or
d
(5 ºC is the minimum day temperature).
t
Wait or press
OFF
button
e
to switch back to the thermostat-controlled system.
t
In order to save the batteries you are advised to reset the night-temperature until the display shows the
‘- - -‘ signal.
Setting the timer function
t
Select the timer function by briefly pressing
SET
button
f
a few times.
t
Now press the
SET
button
f
longer until P1 (
) starts flashing.
t
Set the hours with button
c
and the minutes with button
d
.
t
Briefly press
SET
button
f
for the next timing.
t
Once all 4 timings have been set, press
OFF
button
e
to end the presetting.
Operation (remote control)
Igniting the fire
t
Open the gas turncock that is fixed in the gas pipe leading to the stove.
t
Press “
O I
” switch
g
on the gas control block in the “
I
” position.
t
Turn control button
h
on the gas control block to the
ON
position.
t
Simultaneously press buttons
e
and
c
on the handset. A short acous-
tic signal indicates the start, and is followed by short acoustic signals
(0.2 sec/signal, 1Hz.) until the pilot flame and the chief burner are ig-
nited. After the main burner has lit, the flame height will automatically
go to the maximum position.
Possible error messages
t
Long signals (0.8 sec. signal with 0.2 sec. interval) during lighting
Â
: batteries of the receiver are almost
empty. (After hearing this signal, you can switch on the appliance for about another 10 times.)
t
5 seconds continuous signal
Â
: error message. One of the cables may not be connected, or the “
O I
” switch
is not in the “
I
” position.
t
5 short signals (0.2 sec. signal with 0.2 sec. interval)
Â
: ignition of the pilot flame and the main burner has
failed. Possible cause: air in the pilot burner pipe.
Important: If the pilot flame has gone out you must wait at least 5 MINUTES before repeating the
above-mentioned steps.
R
Q
!
