WANDERS Boreal, Руководство пользователя и инструкция по установке

Страница: 18 / 60

18
The airsupply control
The shaking bar
Energy saving valve
Open the large ornamental cover and the door (see
photograph) and put some balls of paper or firelighters
in the stove with some wood kindling on top. Fully open
the air supply valve and the energy-saving valve (see
photograph). Open the grate shaker with the shaking
bar and keep the ash collector open for the first five to
ten minutes for extra air supply (see photograph). Light
the kindling and leave the door ajar for extra air supply.
Once the kindling is burning you can add extra fuel and
close the door, the shaking grate and the ash pan. Do not
place more than three logs in the stove at a time. Once
the stove is burning nicely, you can first close the energy-
saving valve and, if necessary, then turn the air supply
valve to slow down the fire. Be sure that there is always
enough ventilation when the woodstove is burning.
Open the energy-saving valve before putting logs on the
fire to avoid smoke entering the room. After replenishing
the fuel you can push the valve close again.
If you have a revolving version you can turn the stove
by turning the pull-out switch. You can turn the stove at
most 60º to the left and 60º to the right for reasons of fire
safety requirements.
Pull-out switch
It is prohibited to light the stove with liquids like petrol
or spirits. Do not have the cooker hood on in the room
where you operate your stove.
Never touch the varnished parts when you heat your
stove.
Lighting the stove for the first time
When you light the stove for the first time, the hearth
must still ‘anneal’ and temper itself. The unit has a
heat resistant lacquer which must burn in the stove at
Avoid finger marks
Do not touch the glass of the stove with your fingers.
Finger marks will burn into the glass and cannot be
removed later.
Discolouration of walls, ceilings and grates
The walls, ceilings and grates may show some
discolouration after lighting your hearth. This
is caused by the dust particles that burn in the
convection cover. This is a natural process for
which WANDERS cannot be held responsible. To
minimize discolouring we refer to the advice given
for atmospheric hearths. Your installer can give you
more information about this.