Volume:
Controls the total
output volume of each channel.
Gain:
Turning this control
clockwise will increase the
amount of gain applied to the
signal path of each channel.
Bass:
Adjust the amount of
low-end frequencies, turning
clockwise will increase the
levels, counter clockwise to
decrease.
Treble:
Adjust the amount of
high-end frequencies, turning
clockwise will increase the
levels, counter clockwise to
decrease.
Gain Level (Side switches L
and R):
Set the switch
• top for maximum gain
• middle for medium gain
• bottom for lower gain
Voicing (Side switches L and
R):
Set the switch
• top for hard clipping (crunchy)
• middle for blended clipping
• bottom for soft clipping
(smooth)
MIDI:
Connect a 3.5mm TRS
MIDI cable via an adapter (if
connecting from one of our
other midi pedals you can use
3.5mm TRS to 3.5mm TRS) - In
at the bottom Triangle, Out at
the Top. See MIDI Section on
next page for more information.
Connections:
This pedal has 2 pairs of input and output jacks: if you are using
only one set connect to the jacks marked with solid triangles; if you are using both
sets, the outline triangles indicate the separate output for Channel 1 and input for
Channel 2. This allows you to connect both channels independently (e.g to a loop
switcher), insert a pedal between the channels, or run in stereo.
Power Draw:
55mA
,
9-18V Center Negative DC supply only, do not exceed 18V DC
Channel 1:
Classic / vintage
“Blues Breaker” voicing
Channel 2:
Original Pantheon
(Modern “Boutique” style)
voicing
Presence:
Global presence control to add sparkle and
top end to both channels, start off with this turned all the
way counter-clockwise and adjust to suit. The presence
and treble controls are controlling different frequencies, so
multiple tones can be found by cranking presence up and
treble down, and vice versa.
Order:
Change the
channel stacking
order with this
switch if you are
using only one input
and output cable.
NOTE: We recommend disconnecting the internal 9V battery if this pedal is used with a power supply.
If the power supplied is insufficient LEDS may flicker when a foot switch is pressed to indicate this.