Assembly
Step 1
Remove
transportation blocks
from the bottom of each panel
before beginning assembly. Each
Panel should have two blocks.
Step 2
Place the floor on a firm and level base,
ensure base has suitable drainage free
from areas where standing water can
collect. (See front page on base
requirements).
4
Fix the hinge to the door
using 30mm screws ensuring
that the screws go through
to the door framing.
Step 3
21x 30mm Screws
30mm
screw
1
3
13
13
Step 4
Fix the corners with 2x 50mm
screw as shown in diagram.
Do not secure the building to the
floor until the roof is fitted. Fix
the panels onto the floor using
50mm screws in alignment with
the floor joists
11x 50mm screws
50mm
screw
2
5
Step 5
Fix door gable and Plain side
using same method shown in
step 5.
Position the panels so there is
equal spacing between the floor
and cladding on all four sides.
17x 50mm screws
50mm
screw
1
5
