DECALING
1. After cutting out the decal, dip in water for 10 seconds, remove and let stand for 1 minute.
Slide decal onto surface, position and then blot off any excess water.
2. Lightly brush Micro Sol® on top. This will soften the decal allowing it to conform to
irregular surfaces. DO NOT TOUCH DECAL while wet!
3. When the decal is thoroughly dry, check for any trapped air bubbles. Prick them with the
point of a small pin or hobby knife blade and apply more Micro Sol®.
11. Glue the roofs (20) onto both wings. Then glue on the vents (33) and the small
skylights (21).
12. Finish by gluing the wings to the main structure, using the tab on the main base to
fit into the indentations on the wing bases.
21
33 x 3
33 x 3
20
indentation
21
33 x 3
33 x 3
20
Tab
