5
12
8
9
8
10
11
5) Carefully thread the Rod (2x 8, one per doorway) through the opening at the top of the Braces and glue where
parts meet.
6) PLEASE NOTE: Although similar, there are actually three sizes of Tension Brackets (9, 10 & 11). Glue eight
Small Brackets (9) with one end touching the Brace on either side of the doorway directly on the four 010 x .050"
plastic bands. Repeat for the opposite door.
7) Glue four Medium Brackets (10) at random on the top 010 x .050" band along each side of the kiln (eight total).
Glue Large Brackets (11) at random to the top of both middle 010 x .070" bands along each side of the kiln (two
per band, eight total).
8) Use the raised ridge on the underside to align parts and glue Dome (5) to tops of wall assembly.
If you wish to model an earlier coal-fired kiln, skip to step 11.
9) PLEASE NOTE: To simplify alignment of the Air Line (12), you may wish to install a Gas Burner (15), and/or the
Air Supply Pipe (13) as shown in the next step before proceeding. When installing the Air Line, be sure the small
notches are on the bottom and face downward to align with each Burner. The small pin on the outside of the Air
Line aligns with the flat extension on the Base and is the mounting point for the Air Supply Connector (14).
