26
27
Clean the spray gun
•
before each change of spraying material
•
at least once a week or
•
several times a week if required by the spraying medium and depending on the
degree of fouling.
Detailed
Cleaning
1. Disassemble the spray gun
2. Clean the air cap (Pos. 1) and the material nozzle (Pos. 3) with a soft brush and
cleaning fluid.
3. Clean all other components and the gun body with a soft cloth and cleaning fluid.
4. Coat the following parts with a thin layer of grease:
•
Molla dell'ago (Pos. 16)
•
all sliding parts and bearing points.
The moving internal parts must be greased at least once a week.
The springs should always be coated with a thin layer of grease. For this, always use
a non-acidic, non-resinogenic grease and a soft brush. Assemble the gun again in
reverse order.
8
Trouble shooting
Warning
Prior to any retooling the spray gun should be depressurized state, i. e. atomising air
as well as the material pressure - risk of injury.
Error
Cause
Troubleshooting
Gun drips /
sprays when not
in use
Air pressure too low
Material hose too hard
Increase air pressure to at least
2 bar
use softer hose
Pulsating or
shimming
spray jet
Material volume too low
Wrong air cap position
Fill in material
Adjust air cap position
9
Disposal of cleaning and servicing substances
Waste spraying media and waste material from cleaning and servicing must be dis-
posed of in accordance with all applicable local and national regulations.
Warning
Observe the instructions issued by the manufacturers of the spraying and cleaning
material at all times.The improper disposal of waste material endangers the health of
human beings and animals!
10
Technical data
Net weight:
780 g
Material nozzles available:
0,5 • 0,8 • 1,0 • 1,2 • 1,5 • 2,0 mm ø
Aircaps:
Round-jet aircap V 10 109 01 053
(for material-nozzle sizes 0,5-1,5 mm)
Round-jet aircap V 10 109 01 203
(for material-nozzle sizes 2,0 mm)
Connection:
Air connection:
G 1/4"
Material Inlet:
Silicon hose 4 x 8 mm
ø transparent
or PVC hose 5 x 1,5 mm
ø
Pressure ranges:
Min. input air pressure
2 bar
Max. input air pressure
8 bar
Max. material pressure
1,5 bar
Max. operating temperature
of the Spray gun:
43°C
Noise level
(measured at approx.
1 m from the spray gun)
:
83 dB(A)
Air consumption:
Atomising air pressure
SIL 42
SIL 43
1 bar
56 l/min
71 l/min
2 bar
98 l/min
130 l/min
3 bar
140 l/min
180 l/min
4 bar
179 l/min
222 l/min
Right to effect technical changes reserved.
