
Hydraulic Oil Changing Procedure
Hydraulic Oil Recommendations
NOTE: This decal is located on the hydraulic reservoir.
Hydraulic Oil Change Procedure
Replace hydraulic oil in spring and fall intervals in colder, winter climates.
1. Properly locate platform
a. Gravity down units – lower to ground level
b. Power down units – raise to bed level
2. Using a clean syphon, empty oil from hydraulic reservoir
3. Inspect cleanliness of empty reservoir
a. If clean, proceed to next step
b.
If dirt is visible, remove power unit and clean hydraulic reservoir.
NOTE: For power
down units, safely support platform prior to disconnecting hoses from power unit.
4. Add approximately 4.0 liters of new hydraulic fluid to reservoir and fill to “Fill Line” marked on
power unit (approx. 1” below the top of the reservoir)
5. Complete 3 cycles of raise and lower and 2 cycles of in and out to bleed any air that may have
been introduced
6. Put breather back on reservoir
37
04/23/19
Содержание GTSL
