Roller Wear Check
Roller, Dominos Spec
Roller Bearing
27866535/9123053
10010197
1. Remove the rail cap to expose the 1
st
roller in the track – Check must be done to both sides
2. Lower lift gate to set on top of floor jack – raise jack just enough to take weight off the front roller
3. Replace all rollers if excessive side to side or up and down movement is noticed. Movement
indicates the bearing is worn out
4. Fork lift or crane is required to slide the lift gate totally out to replace all (8) Rollers if the liftgate is
not equipped with Serviceable Rail End Cap kits. These kits are field retrofittable
Bearing Replacement Procedure
1. Remove worn bearing using step tool and 3 lb hammer. Step tool to be 1.20 dia for ¾” in length
then 1.30 dia the rest of the shaft.
2.
Install new bearing using same tool and hammer. Bearing should be flush on both sides with
roller.
NOTE: bearing is press in and does not require any adhesive.
After removing the wheels,
inspect the axles for wear. If
axles are worn, they can be
replaced with the Waltco two-
piece axle replacement kit. The
part # for the kit is 80004736
33
04/23/19
Содержание GTSL
