walser Walimex Pro 380 Bi Color RLL-380BV, Инструкция по эксплуатации

Страница: 19 / 22

36 37
8.2. Setting brightness (dimmer function)
1. Make sure the power switch (8) is OFF before connecting the
power cable or batteries.
2. Make sure the device is connected to a power supply before
turning it on.
3. Switch to <BATTERY> if you’re using batteries and switch to
<CABLE> if using AC adapter.
4. After turning on the light, you can control the dimming via
dimming knob.
5. Turn the power adjust wheel (12) to set the device to the
desired level of brightness.
6. Twist the knob down from 0 % and up to 100 % of
brightness.
8.3. Setting color temperature
• Control the color temperature via color temperature wheel (13).
• Twist the knob down to 3000K and up to 5600K of color temperature.
8.4. Setting light sectors
Activate or deactivate the respective light sector by pressing the red buttons of
the light sector switches (10).
The status light of the corresponding LED (11) indicates the selection of the sector.
If no sector is activated, the ring light is not lit.
• LED below the red button is on - sector activated.
• LED below the red button is off - sector inactive.
9. Transporting, storing the device
WARNING
Danger of fi re caused by hot parts of the equipment. Allow the device to cool
down completely.
• Switch off the device (See „Switching the device on, off“).
• Allow the device to cool down completely.
• Unplug the power supply cable from the device and /or remove the batteries.
• If necessary, clean the device (See „Cleaning the device“)
• Lay the device and all disassembled elements into the original article packa-
ging box and transport or store as specifi ed in the technical specifi cations.
10. Troubleshooting
Problem Possible cause Remedy
The device is
switched on, but
does not show any
function.
Mains cable not plugged in
or not plugged in correctly.
Plug the mains cable in
correctly
Batteries are almost
exhausted
Charge the Batteries
The illuminant
does not light
The device is switched off Switch on the device
The device has not enough
power
Increase the power of the
dimmer control
No light sector selected Set minimum 1 light sector
The device is defective
Repairs must only be
carried out by a skilled
electrician
11. Maintaining the device and cleaning
WARNING
Danger of electric shock and danger of fi re due to short circuit.
Have the device repaired by an electrician immediately.
WARNING
Danger of cutting and splintering caused by breaking or bursting illuminants.
10
11
12
13
9
7
8