Wallgate SNC-02, Руководство по эксплуатации продукта

Страница: 19 / 24

Revision 3
19
SNC-02 Product Manual
5.3 Water Connections
NOTE: Before you carry out the following steps, flush the water supply pipes to
remove any debris and trapped air.
NOTE: Fit a Y strainer in the water supply feed pipes prior to connection of
solenoid valve, especially on older installations where loose particles from
ageing water pipes can cause a blockage and/or damage to the outlet or
solenoid valves.
NOTE: The shower nozzle must be fed by a blended supply that complies with
the regulatory standards, set to the necessary temperature range(s). If a TMV is
used it must be positioned before a solenoid valve.
NOTE: Use of any pipe sealing compound should be avoided to prevent
blockages and damage to the shower nozzle and water solenoid valves.
NOTE: It is recommended to fit a service isolating tap on the water supply feed
before solenoid valve. This allows for ease of maintenance when required. The
isolating taps are not supplied by Wallgate and should be purchased
separately.
1.
Connect ½” BSP female fitting to male ½” BSP thread on shower nozzle
housing.
2. Figures 3, 4 and 5 are for illustration only, installation should be made in
accordance with site-specific plumbing requirements.
5.4 Ceiling Shower Spray Pattern
The ceiling shower will have varying spray pattern dimensions depending on
mounting height and water flow rate. Figure 7 on the following page has a table
indicating the various spray diameters at two different flow rates, 6lpm and 8lpm.