Wallenstein WP845, Руководство оператора

Страница: 54 / 72

8. Storage
At the end of the season or when the machine is not going to
be used for an extended period of time, completely inspect all
of the major systems. Replace or repair any worn or damaged
components to prevent unnecessary down time at the beginning
of the next season. Touch up scratches or dents.
For reference, see Fig. 53 on page 55 .
8.1 Storage Safety
WARNING!
Do not permit children to play on or around
stored machinery or equipment. Sharp edges,
unexpected movement, trips, falls, and other
hazards can cause serious injury or death.
W105
• Store the machine in a dry, level location away from human
activity.
• Store the machine indoors, where possible.
• Support the frame with planks, if required.
8.2 Place the Machine in Storage
For information about engine storage, see the engine
manufacturer's manual.
1. Turn off the chain saw and remove it from the holder.
2. If required, remove the winch rope and strap from the log.
3. Wind the winch rope into the winch.
4. Fully retract the push block.
5. Move the hydraulic controls to neutral.
6. Stop the machine.
For instructions, see
Stop the Machine on page 32 .
7. Actuate each hydraulic control to relieve the pressure.
8. Remove all material from the lead-in chute, log-loader
chute, splitting cradle, and splitter chute.
9. Use a pressure washer or water hose to thoroughly wash
the machine. Remove all dirt, mud, and debris.
10. Check all moving parts for entangled material. Remove all
entangled material.
11. Check the condition of the winch rope. Replace or adjust
the rope, as required.
12. Do one of the following:
-
If the machine will be in storage for one to three
months, add stabilizer to the engine fuel and drain the
carburetor.
-
If the machine will be in storage for longer than three
months, replace the engine fuel with an alkylate or
appropriate engineered fuel. These fuel types prevent
the buildup of insoluble solids (deposits) in the engine.
For more information, see
Engine Fuel on page 57 .
For instructions, see Replace the Engine Fuel .
13. Park the machine in the storage location.
14. Disconnect the tow vehicle.
For instructions, see
Disconnect from a Ball-Mount Hitch
on page 53 .
15. Adjust the trailer jack until the machine is level. If soft
ground is unavoidable, place boards or plates under the
jack to increase the surface area.
16. Chock the machine wheels to prevent accidental movement
and increase the wheel bearing life.
17. If indoor storage is not possible, cover the machine with
a waterproof tarp. It is recommended that the machine be
stored indoors.
8.2.1 Replace the Engine Fuel
1. Remove the current fuel from the engine.
Operate the machine until the fuel tank is empty or drain the
fuel tank and properly dispose of the fuel.
2. Add new fuel to the engine.
For instructions, see
Add Fuel to the Engine on page 29 .
3. Start the machine.
For instructions, see
Start the Machine on page 32 .
4. Wait five to 10 minutes for the fuel to flush the carburetor.
5. Stop the machine.
For instructions, see
Stop the Machine on page 32 .
8.3 Remove the Machine from
Storage
1. Complete the Pre-start Checklist on page 26 .
2. Complete the required maintenance.
For maintenance requirements, see the
Maintenance
Schedule on page 58 .
Storage
WP845 / WP875
Trailer Firewood Processor
54