Wallenstein WP845, Руководство оператора

Страница: 29 / 72

6.4.4 Add Fuel to the Engine
WARNING!
Fuel vapors can explode causing
injury or death. Do not smoke while
refueling. Keep sparks, fl ames, and hot
components away.
W027
CAUTION!
Fuel vapors are very toxic. Breathing fuel vapors
can cause irritation, illness, or unconsciousness.
Fill the fuel tank outdoors or in a well-ventilated
area.
The engine requires clean, fresh, unleaded gasoline with a pump
octane rating of 87 or higher (research octane number [RON]
of 91 or higher). Gasoline with up to 10% ethanol (gasohol)
is acceptable. For more information, see
Engine Fuel on page
57 .
For information about use at high altitudes, see the engine
manufacturer's manual.
Fuel tank capacity: 1.26 US gal (5.74 L).
1. Stop the machine.
For instructions, see
Stop the Machine on page 32 .
2. Wait a minimum of five minutes for the engine to cool.
3. Turn the fuel cap counterclockwise to remove it.
4. Add the correct type and amount of fuel to the tank until the
fuel level is visible 1/2 inch (12 mm) below the filler neck.
Leave room for expansion.
Do not overfill the tank.
5. If fuel is spilled, carefully clean it up and wait until the fuel
dries before starting the engine.
6. Install and secure the fuel cap to prevent spillage.
6.4.5 Check the Engine Oil Level
IMPORTANT! For more information about engine oil, see
the engine manufacturer's manual and
Engine Oil on page
57 .
Operating the engine with a low oil level can cause engine
damage that is not covered by the warranty.
The engine must be in a level position for the
dipstick to show the oil level correctly.
Check the engine oil level before each use.
1. Park the machine on level ground.
2. Set the machine to a safe condition.
For instructions, see
Safe Condition on page 9 .
3. Pull out the oil-level dipstick and wipe it clean.
4. Fully reinsert the oil-level dipstick.
5. Pull out the oil-level dipstick and check the oil level.
The oil level is correct when oil is visible on the dipstick
from the end to the full (upper) mark.
6. Do one of the following:
-
If the oil level is correct, continue with Step 7.
-
If the oil level is low, add oil until the oil-level is at the
full (upper) mark. For instructions, see
Add Oil to the
Engine on page 30 .
7. Insert and secure the oil-level dipstick.
01823
Fig. 17 –
Check the engine oil level
WP845 / WP875
Trailer Firewood Processor
Operating Instructions
29