Wallenstein WP525, Руководство оператора

Страница: 34 / 72

6.8 Stop the Machine
IMPORTANT! Do not choke the carburetor to stop the
engine.
1. Stop all machine operations (winching, cutting, and
splitting).
2. Move the hydraulic controls to neutral.
3. Move the engine throttle control to the STOP position to
turn off the engine and close the fuel shutoff valve.
4. Activate each hydraulic control two or three times to relieve
the hydraulic system pressure.
5. Remove the chain saw from the holder and turn it off.
6.9 Emergency Stop
In the event of an emergency:
1. Move the hydraulic controls to neutral.
2. Move the engine throttle control to the STOP position to
turn off the engine and close the fuel shutoff valve.
3. Remove the chain saw from the holder and turn it off.
4. Remove the cause of the emergency before starting the
engine and resuming work.
6.10 Process Logs into Firewood
IMPORTANT! Once every hour of operation, remove all
wood chips and saw dust that are on the machine and on
the ground below the machine. Wood chips and saw dust
that accumulate on and below the machine may damage the
machine during continuous operation.
The following procedure describes how to efficiently process
logs into firewood:
1. Set up the machine.
For instructions, see
Set Up the Machine on page 35 .
2. Use the winch to pull a log into position at the log-length
guide.
For instructions, see the following:
-
Winch Operation on page 42.
-
Position the First Log on page 45.
-
Position the Next Log on page 47.
-
Position the Last Log on page 47.
3. Use the chain saw to cut the log. Let the cut section fall into
the splitter.
For instructions, see
Cut a Log on page 48 .
4. Split the cut log.
For instructions, see
Split a Log on page 48 .
5. While the push block automatically returns to the retracted
position, repeat step 2.
6. When the push block is in the retracted position, repeat
steps 3 through 5.
Continue this process until you produce the desired amount
of firewood.
Operating Instructions
WP525
Firewood Processor
34