Wallenstein FX40, Руководство оператора

Страница: 20 / 48

5. Using a straight edge, transfer a mark from the end
of one tube section to the other section as shown.
00940
Fig. 6 – Transferring the mark
6.
Add 2 inches (50 mm) to that measurement and
place a second mark on the outer plastic tube. This
is where the plastic shielding needs to be cut off.
00941
Fig. 7 – Place mark to cut plastic tube
7. Cut the plastic tube off at the mark, leaving the
steel shaft inside.
00942
Fig. 8 – Cut plastic tube at the mark
8.
Using the cut-off length of plastic tube as a guide,
mark the steel tube. Align the end of the plastic
tube with the end of the steel shaft.
00943
Fig. 9 – Marking steel tube.
9. Cut the steel tube off at the mark.
10. Using the cut-off length of plastic tube to mark the
remaining cuts, repeat this process for
BOTH PTO shaft
halves.
Place the end of the steel shaft to be cut off in a
vice so it is easier to control your cut.
11. Remove the burrs from the edges of the steel shaft
that were cut. Clean the steel shaft halves.
12. Grease the inner tube so the tube halves slide
together easier.
00868
Fig. 10 – Grease the inner tube
13.
Assemble the two halves of the PTO shaft.
14. Make sure the shaft can telescope freely before
installing. If it does not, separate the two parts and
inspect for burrs or cuttings on the shaft ends.
IMPORTANT! The two PTO shaft halves should overlap
inside at least 6" (150 mm).
Sizing PTO Shaft
FX40
PTO-driven Log Skidding Winch
20