Wallenstein FX110R, Руководство оператора

Страница: 23 / 50

FX66, FX85/R, FX110/R, FX140/R
PTO Skidding Winch
Attaching Winch to Tractor
23
5.
Take the PTO shaft that came with your machine,
fully collapse it, and measure the distance between
the locking yokes.
Call this value
B
.
Fig. 11 – Measurement B
6. If this collapsed length B is longer than
measurement A from Step 4, the PTO shaft must
be shortened.
4.2 Shortening PTO Shaft
1. Subtract A from the uncut PTO shaft measurement
B . (B – A)
The result is how much both halves of the PTO
shaft need to be shortened. Call this value C .
B – A = C
2. Pull the PTO shaft apart, then measure and cut the
length C from both the outer plastic covers and the
inner metal tubes.
Tip: Use the cut off piece of outer shielding to
mark the inner tube. Leave the steel center tubes
longer than the plastic outer tubes, otherwise they
can be harder to put back together.
Fig. 12 – Cut off the Length C from both PTO Shaft halves
3.
Use a file to remove the burrs from the edges that
were cut.
4. Assemble the two halves of the PTO shaft.
5. Make sure the shaft can telescope freely before
installing. If it does not, separate the two parts and
inspect for burrs or cuttings on the shaft ends.
6.
Install the PTO shaft, then raise and lower the
attachment to check clearances.
A correctly sized shaft should never bottom out or
come apart.
IMPORTANT! The two halves of the PTO shaft
should overlap at least 6" (150 mm).
4.3 Winches with Remote Control
FX85 R , FX110 R and FX140 R models include a
wireless remote winch control. The system consists of
a hand-held transmitter control and a receiver mounted
on the winch.
For the remote to function, the following electrical and
hydraulic connections to the winch must be made.
Electrical Connection
•
A
12 VDC, 1.5 amp
power source is required from
the tractor electrical system.
• The white wire from the receiver should be
connected to positive, black to ground.
• Connectors are not supplied on the wire ends.
Wire ends are supplied bare to permit different
adaptations.
Hydraulic Connection
• A valve on the winch controls the winch clutch.
The system is designed for an open-center
hydraulic system. Oil flow required is 1–2 gpm
(3.8–7.5 L/m) .
• The 1/2" pressure and return hoses have quick-
disconnect ends and are connected to the tractor
rear remote power supply.
•
The hoses have colored, protective caps to
indicate function. Red is pressure and blue is
return.
NOTE: In the event pressure and return hoses
are not identifiable, check the connection
on the control valve. An 'R' is indicated on
the return port. A 'P' is indicated on the
pressure port.